Manual kawasaki er6f. 2006 2019-02-07

Manual kawasaki er6f Rating: 7,7/10 1841 reviews

Kawasaki Fault Codes

manual kawasaki er6f

Direction of Engine Rotation When rotating the crankshaft by hand, the free play amount of rotating direction will affect the adjustment. Left Switch Housing Lead 4. Measure the clearance when engine is cold. Special Tool - Hand Tester: 57001-1394 Terminal Voltage Standard:. Main throttle sensor trouble Inspect see chapter 3. .

Next

2006

manual kawasaki er6f

Seat Height 790 mm 31. Oxygen Sensor Heater Fuse 10 A 6. Therefore, be sure to read the owner's manual and supplementary documents that were originally supplied with your product. Right Switch Housing Lead 2. Rear Wheel Rotation Sensor 6.

Next

Kawasaki Service Repair Manual Download

manual kawasaki er6f

If the bearing play, roughness, or binding is found, replace the bearing. Measure the clearance when engine is cold. Torque - Oil Filter: 17. If the fan does not rotate, the fan motor is defective and must be replaced. Oxygen Sensor Heater Signal Europe 4.

Next

KAWASAKI Motocycle Manuals Resource

manual kawasaki er6f

If the connector is corroded or dirty, clean it carefully. Moreover, if the owner's manual supplied with a product is revised, this website may provide without notice the revised version, instead of the manual that had originally been issued at the time the product was released. Fuel injector trouble Inspect see chapter 3. Sealant - Kawasaki Bond Silicone Sealant : 56019-120 Torque - Oil Pressure Switch: 15 N·m 1. Swelling or high spots indicate inter- nal damage, requiring tire replacement. Ball Bearing and Needle Bearing Do not remove pressed ball or needle unless removal is absolutely necessary. Front Wheel Rotation Sensor 6.

Next

Download Owners Manual For Kawasaki Er6f User 2019 PDF Book

manual kawasaki er6f

Power Supply to Rear Wheel Rotation Sensor 8. The initial maintenance is vitally important and must not be neglected. As such, Kawasaki will not be held responsible for any loss or damage that may be sustained in association with the matters indicated below, regardless of whether the occurrence of such loss or damage is known to Kawasaki, or the possibility of indemnity for such loss or damage is made known to Kawasaki by a third party. The fault codes are 2 digit numbers. Make sure the area is well-ventilated and free from any source of flame or sparks;. Valve guide worn Inspect and replace see chapter 5.

Next

Kawasaki ER

manual kawasaki er6f

Do not use any other battery except for a 12 V sealed battery as a power source. The thermostat continuously changes its valve opening to keep the coolant temperature at the proper level. . The push rod does not return to its original position once it moves out to take up camshaft chain slack. Front Inlet Solenoid Valve 18. Remove the oxy- gen sensor see Oxygen Sensor Removal in the Electrical System chapter.

Next

KAWASAKI Motocycle Manuals Resource: Kawasaki Ninja 650R ER

manual kawasaki er6f

Clutch Lever Free Play Inspection. Do not drop or shock the valve seat cutter, or the dia- mond particles may fall off. To Front Right Turn Signal Light Lead 4. When this accumulation is suspected or observed, flush the cool- ing system. Inlet Air Pressure Sensor 10.

Next

KAWASAKI ER

manual kawasaki er6f

Tires not recommended for the motorcycle were installed incorrect tire size. Because of the danger of highly flammable liquids, do not use gasoline or a low-flash point solvent to clean the element. Do not touch the spark plugs or stick coils while the engine is running, or you could receive a severe electrical shock. No matter how hard the brake lever is pulled, the brake fluid pressure in the caliper is maintained at a given level. Learn and ob- serve all the rules below.

Next