The audio board cable is included in the Cable Kit, spare part number 531211-001. Boot Options Set the following boot options: f9 and f10 Delay seconds —Setthe delay for the f9 and f10 functions of Setup Utility in intervals of 5 seconds each 0, 5, 10, 15, 20. These antennas are not visible from the outside of the computer. A system restore point allows you to save and name a snapshot of your hard drive at a specific point in time. To restore the system from the partition, follow these steps: 1. Remove the display panel assembly 2 from the display enclosure.
The light on the power button is visible only when the computer is open. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system. Even if the spark is neither felt nor heard, damage may have occurred. Off: The computer is off or in Hibernation. Removal and replacement procedures Equipment guidelines Grounding equipment must include either a wrist strap or a foot strap at a grounded workstation.
Remove the memory module 2 by pulling it away from the slot at an angle. Nothing herein should be construed as constituting an additional warranty. Rear component Component Description Vent Enables airflow to cool internal components. Removal and replacement procedures Battery Description Spare part number 6-cell,2. Do not allow another hard surface, such as an adjoining optional printer, or a soft surface, such as pillows or rugs or clothing, to block airflow. Disconnect all external devices connected to the computer.
Disconnect all external devices connected to the computer. The wireless module compartment accepts both full-sizeand half-sizemodules. Item Component Description 1 Product name This is the product name affixed to the front of the computer. To start Setup Utility: » Open Setup Utility by turning on or restarting the computer. Recovery discs have been included for computers that do not have a partition.
The audio board cable is included in the Cable Kit, spare part number 531211-001. If you replace the module and then receive a warning message, remove the module to restore computer functionality, and then contact technical support through Help and Support. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system. The option to print the manual has also been provided, and you can use it by clicking the link above - Print the manual. Remove the wireless antenna transceivers and cables 3 from the display enclosure.
Use the computer only on a hard, flat surface. Another possible reason is that there is something wrong with laptop motherboard. Remove the memory module: 1. Setup Utility Navigating and selecting in Setup Utility Because Setup Utility is not Windows-based,it does not support the TouchPad. Follow the local laws and regulations in your area for computer battery disposal.
Open Setup Utility by turning on or restarting the computer. When you install the processor, the gold triangle 3 on the processor must be aligned with the triangle 4 embossed on the processor socket. Component Description 1 Speaker grill Two integrated speakers produce sound. Lift up the front edge of the module 2. To see wireless regulatory notices, refer to the section of the Regulatory, Safety and Environmental Notices that applies to your country or region.
The light on the power button is visible only when the computer is open. The keyboard screws are identified by a keyboard icon embossed on the base enclosure. When the battery reaches a critical low-batterylevel, the battery light begins blinking more rapidly. Remove the Bluetooth module: 1. Reverse this procedure to install the speaker assembly. Intel, Celeron, and Pentium are trademarks of Intel corporation in the U.