Remove the steering column lock cylinder housing and the steering column shaft from the steering actuator housing. Third door if equipped On SuperCab models a third door is located behind the passenger door. Be careful when braking, especially on loose snow or gravel. Cross chains under the trailer tongue and allow slack for turning corners. Before completing the above driving modes, the engine must be warmed up and at operating temperature. However, avoid taking any unnecessary risks. Transmission operates in gears one through four.
Drive out the gearshift lever pin 7W441 from the shift tube. On fixed steering column, install the bearing retainer. The foglamp indicator light located to the right of the control will illuminate. Use 1 First gear and set the parking brake fully. Improperly inflated tires can affect vehicle handling and can fail suddenly, possibly resulting in loss of vehicle control. Slide the steering column bearing tolerance ring off the steering column shaft.
Connect safety chains to the vehicle frame or hook retainers. Depress to activate all indicators simultaneously. Always disconnect the battery before servicing high current fuses. The overdrive function allows automatic upshifts to second, third and fourth gear. Even after a fuse is replaced, it may continue to blow if the cause of the overload is not identified and corrected. Overdrive — The normal driving position for the best fuel economy. To prevent the risk of injury, make sure children sit where they can be properly restrained.
Always use a clean sponge, washing glove or similar device and plenty of water for best results. Use only fluid that meets Ford specifications. Remove the shift tube clamps. Illumination after releasing the parking brake indicates low brake fluid level. Switch off any unnecessary electrical equipment. Allow sufficient time for each gear to engage. Install the steering column bearing spring.
Remove the gearshift lever 7210. To connect the safety belt, insert the tongue into the buckle. Install the steering column bearing so that the inner race is visible when installed. Mud and water If you must drive through high water, drive slowly. Press switch to tilt the rear of the seat up or down.
If a light fails to illuminate, have the vehicle serviced. Refer to Capacities and specifications. Install the driver side air bag module. Install the steering column shaft bolt. However, the vehicle will not start until the system is disarmed. After air bag deployment, it is normal to notice a smoke-like, powdery residue or smell the burnt propellant.
If it enters the red section, the engine is overheating. Stop the engine and check the engine coolant temperature level as soon as possible. See your Ford dealer for assistance. Refer to Capacities and specifications. High beams Illuminates when the headlamp high beams are on. Anti-theft system if equipped When armed, the anti-theft system prevents unauthorized entry into your vehicle. This may consist of cornstarch, talcum powder to lubricate the bag or sodium compounds e.
To lower the spare tire, insert the jack handle into the rear bumper opening and turn it counterclockwise. Manufacturer identification is located at the end of the webbing on the label. Remove particles such as bird droppings, tree sap, insect remains, tar spots, road salt and industrial fallout immediately. Use an appropriate bearing installer or socket. Never adjust the steering wheel when the vehicle is moving. Rear-facing child seats or infant carriers should never be placed in the front seats.
On fixed steering columns, remove the bearing retainer from the bottom of the steering column shaft. After at least three to five fuel tank fill-ups, fill the fuel tank and record the current mileage reading. Never increase the engine coolant concentration above 60%. Call your local recycling center to find out more about recycling automotive batteries. Install the column shift selector lever plunger. The system automatically turns off after 25 seconds or when the ignition is turned to the Start or.
However, if the normal brakes fail, the parking brake can be used to stop your vehicle in an emergency. Blown fuses are identified by a broken element. The foglamps can be turned on only when the headlamps are in the position. Remove the transmission selector lever arm and support 7302. If the engine does not start within five seconds, wait ten seconds and try again. Indicates that vehicle information related to recycling and other environmental concerns will follow. Remove the steering column lower bearing retainer.